.For the prices or for order, please contact your sales representative Kemex.
Safety manual and Operation
DTW-208 et DTW-210
MANUAL TENSIONER
GENERAL SAFETY CONSIDERATIONS:
Kemex Strapping Systems 1850, Transcanadienne, ++++.Dorval (Québec) + + . Tél: 514-685-1119 +++++.800-755-3639 ++. +..Fax: 514-685-2228
1. Before using tool read its operation instructions.
2. Several combinations of strap and seals can be used
with this tool. Use the correct Acme products for
your application. If you need help, contact your local
Kemex representative.
3. Wear eye and hand protection.
4. Keep work areas uncluttered and well lighted.
5. Take good care of the tool. Inspect and adjust it
daily. Replace worn or broken parts. Clean and
lubricate it weekly.
6. Seals must be properly crimped or notched. Follow
the operating instructions in this manual.
7. Retract strap end back into dispenser when not in
use.
STRAP PLACEMENT AROUND LOAD:
1.Place strap around load as shown in the illustrations.
OPERATING INSTRUCTIONS:
DTW-208
DTW-210
SAFETY PROCEDURES FOR TOOL
OPERATION:
1. Follow the operating instructions.
2. Place strap properly around the load.
3. Make sure that the bottom strap is inserted under
the gripper + properly.
| TOOL (Part No.) |
TYPE STRAP: |
WIDTH |
THICKNESS |
DTW-208 |
HI TENSILE |
1-1/4" Min. |
.025" Min. to .050" |
DTW-210 |
HI TENSILE |
2" Min. |
.044" Min. to .050" |
Warning
Failure to place the strap properly around the load or an unstable or shifted load could result in a sudden loss of
strap tension during tensioning. This could result in a sudden loss of balance casing you to fall.
If the load corners are sharp use edge protectors. Failure to follow the above could result in serious injury or death.
With the DTW-208 tool, use only 1-1/4" wide (minimum) x .025" thick (minimum) hi tensile strap. With the DTW-210
tool, use only 2" wide (minimum) x .044" thick (minimum) hi tensile strap. Failure to use the proper tool or strap
can result in serious personal injury. |
2. Thread the proper number of heavy duty seals on both straps, Contact your sales representative for recommendations. Bend the
lower/inner strap backwards to hold seals in place. Bend the upper/outer strap away from the load to permit insertion into the
windlass of tensioner.
INSERTING STRAP INTO THE TOOL:
1. Rotate the tensioning handle all the way down to lock the gripper in the open position. Adjust the drum so that the slot is in line
with angle of strap.
2. Insert lower/inner strap in opening between gripper and base of tensioner until the strap is fully in contact with the inner wall of
the base (strap guide). Make sure that the lower/inner strap is inserted over the base foot. Insert top/outer strap fully into
windlass slot. Approximately 2 to 4 inches should extend beyond drum; cut off any excessive length before tensioning.
